Model Number:RF433MHz Smoke detector
Origin:Mainland China
Smart home platform:Other
Certification:CE,RoHS
Type:Smoke Detector
Smoke sensor:Photoelectric
Audible alarm:>85dB/3M
Battery Package:DC 2*1.5V AA Alkaline (LR6,MN1500) or Carbon Zinc battery (R6P)
Operation Current:<10uA (standby); <70mA (alarm)
Alarm Volume:>85 dB(A) at 3 meters
Alarm Sensitivity:0.09 - 0.17 dB/m
Low Battery:2.6 ± 0.1 V
Silence Time:Approx. 10 minutes
Comply to Standard:EN14604:2005/AC:2008
Product Introduction:
Wireless mode: Alarm Transmission frequency RF433MHz or RF868MHz independent (Can be chose as your requirement)
.
Main Feature: When an alarm is activated, all connected smoke detectors will alarm;
Using Remote Controllerto do weekly test and mute sound if faulty warning or check low battery or Interlink wireless smoke detectors make them connected to each other.
Wireless technology with a transmission range of over 100 m (under the open sky) sends and receives messages about fire hazards in the house using radio frequencies, so you get every extra life-saving second to escape.
Featuring a relay function that extends transmission range, this radio-interlinked alarm can be interconnected with up to 24 smoke alarms to create a smart home network with no blind spots, even on different floors or in the basement and garage.
Product Specification:
Smoke sensor: Photoelectric
Type: 433MHz
Audible alarm:>85dB/3M
Mode : RF Smoke detector
Battery Package: DC 2*1.5V AA Alkaline (LR6,MN1500) or Carbon Zinc battery (R6P)
Operation Current:
Alarm Volume: >85 dB(A) at 3 metersAlarm Sensitivity: 0.09 - 0.17 dB/m
Low Battery: 2.6 ± 0.1 V
Silence Time: Approx. 10 minutes
Comply to Standard EN14604:2005/AC:2008
Premium Material: The smoke detector is housed in a flame-retardant, high-temperature resistant ABS material for enhanced quality, durability, and longevity.
433MHz Remote control
Choose a networked alarm arbitrarily, press the center of the cover twice continuously, The green LED starts to flash quickly, and the alarm enters the receiving mode; long press the remote control configuration button (signal button), the red LED is always on, the remote control enters the transmitting mode, wait for the alarm to receive the signal After the number, the green LED stops flashing, indicating that the remote control is successfully networked and you can release the configuration.
Machine button (signal button);
After the device is successfully set, you can press the TEST/HUSH button (test button) of the remote control.
